50 Kg Half-bridge Load Cell

50 Kg Half-Bridge Load Cell / Weight Sensor/ Strain Gauge 

A load cell is a transducer that is used to create an electrical signal whose magnitude is directly proportional to the force being measured. This weight sensor (load cell half bridge 50KG) is suitable for electronic balance and other high accuracy electronic weighing devices.

When measuring, the correct force is applied to the outer side of the strain E-shaped beam portion of the sensor (i.e., a strain gauge affixed to the middle, with a beam of white plastic cover arm) and the outside edges to form a shear force in the opposite direction, i.e., in the middle of strain beam bending necessary changes can occur under stress, strain beam side by another force can not have a barrier.

This 50 Kg Half Bridge Load cell can be used in three different ways :

• Using a sensor with external resistors full bridge measurement range of a sensor range : 50kg. Higher requirements for external resistor.

• The use of only two full-bridge sensors measuring range is the range of the two sensors and : 50kg*2 = 100kg.

• The use of four full-bridge sensors measuring range is the range of four sensors and : 50kg*4 = 200kg.

We have various types of Load Cells, Force Sensor, Flex Sensor and Pressure Sensor. Check our complete collection of Weigh Sensor and Load cell.

Related Links

• Forum How to mount a Half-bridge load cell

• Forum How to wire up 3 wire Load Cell/Strain Gauge to Amplifier

• Arduino Based Bathroom Scale with 50Kg Load cells