PICkit3 Chinese Programmer

The PG164130 is a PICkit 3 in circuit debugger/programmer uses in circuit debugging logic incorporated into each chip with Flash memory to provide a low cost hardware debugger and programmer.

The MPLAB PICkit 3 allows debugging and programming of PIC® and dsPIC® Flash microcontrollers at a most affordable price point using the powerful graphical user interface of the MPLAB Integrated Development Environment (IDE). The MPLAB PICkit 3 is connected to the design engineer's PC using a full speed USB interface and can be connected to the target via an Microchip debug (RJ-11) connector (compatible with MPLAB ICD 2, MPLAB ICD 3 and MPLAB REAL ICE).

We have Various sizes of Programmers.Check out our complete collection of Programmers

Features of PICKIT 3

• PICkit 3 allows debugging and programming of PIC and dsPIC Flash MCU's

• Expensive sockets or adapters are not required

• Minimum of additional hardware needed for debug

• Built in over voltage/short circuit monitor

• Supports low voltage up to 2volts

• MPLAB PICkit 3 contains full speed USB interface to host PC

• Compatible with MPLAB ICD 2, MPLAB ICD 3 and MPLAB REAL ICE

• Erase of program memory space with verification

• Program up to 512K byte flash with the Programmer to go function

• Freeze peripherals at breakpoint

• USB (Full speed 12 Mbits/s interface to host PC)

• Real-time execution

• MPLAB IDE compatible (free copy included)

• Built-in over-voltage/short circuit monitor

• Firmware upgradeable from PC/web download

• Totally enclosed

• Supports low voltage to 2.0 volts (2.0v to 6.0v range)

• Diagnostic LEDs (power, busy, error)

• Read/write program and data memory of microcontroller

Note: This is not original Microchip's PICKit3 this is a clone version. If you want Original PICKit3 get in touch with us we can arrange it for you.

Though this is a clone version we and any of our clients have not faced any issues with this PICKit3 programmer.