Cytron Enhanced 13Amp DC Motor Driver 30A peak (10 seconds) MD10C

  Cytron Enhanced 13Amp DC Motor Driver 30A peak (10 seconds) MD10C

This is Cytron Enhanced 13Amp DC Motor Driver 30A peak (10 seconds) MD10C. The MD10C is a newer version of the MD10B which is designed to drive high current brushed DC motor up to 10A 13A continuously.

It offers several enhancements over the MD10B such as support for both locked-antiphase and sign-magnitude PWM signal as well as using full solid state components which result in faster response time and eliminate the wear and tear of the mechanical relay.

Features:

• Bi-directional control of 1 brushed DC motor.

• Support motor voltage ranges from  5V to 25V.

• Maximum current up to 13A continuous and 30A peak (10 seconds).

• 3.3V and 5V logic level input.

• Solid state components provide faster response time and eliminate the wear and tear of the mechanical relay.

• Fully NMOS H-Bridge for better efficiency and no heat sink is required.

• Speed control PWM frequency up to 20KHz (Actual output frequency is the same as input frequency).

• Support both locked-antiphase and sign-magnitude PWM operation.

• The new MD10C can be powered from a single power source and external Vin is not required.

Specification

• Driver Model : MD10C

• Operating Voltage(VDC) : 5 to 25 (Rev 1.0) , 5 to 30 (Rev 2.0 )

• Arduino Sheild : No- can be used with Wire connection

• Battery Protection Mode : Yes
  

• Peak Current (A) : 30 (10 seconds)

• Continuous Current (A) : 13

• PWM (Lock-Antiphase and Sign-Magnitude) : Yes

• UART : No

• Analog : No

• RC Servo Signal : No

• LED Indicator : Yes

• No. of Channels : 1

• Cooling Fan : No

• Test/Manual Button : Yes

• Polarity Protection : No

• Dimensions in mm (LxWxH) : 75 x 43 x 20

• Weight : 80gram

Package includes:

• 1 x Cytron Enhanced 13Amp DC Motor Driver 30A peak  MD10C

Related Links:

• MD10C Fast Testing

• PSC28A – Controlling MD10C and MDS40A

• SK40C PIC16F887 project 10 – Driving one DC brush-motor with MD10C

• SK40C PIC16F887 project 16 – Driving two DC brush-motor with MD10C by using SKPS

• Controlling MD10C with Arduino, Signed-Magnitude and Locked Anti-phase method